Magnetech’s Saraland, Alabama service center offers diversity of services that provides single-source industrial maintenance in the southeast, including Alabama, Mississippi, Louisiana, Arkansas, Florida, Georgia, and Tennessee. The Alabama center specializes in the repair of electrical-mechanical rotating equipment, including motors, generators, pumps, and turbines, as well as transformers, protective relays, switchgear and circuit breakers.
Magnetech Saraland has been approved as an EASA Accredited Service Center. Magnetech Industrial Services is one of 160 companies worldwide to carry this Accreditation. The EASA Accreditation means the firm successfully demonstrated that it follows the prescribed good practices to consistently deliver quality electromechanical repairs that maintain or improve AC electric motor efficiency and reliability. The criteria for becoming EASA Accredited are based on ANSI/EASA AR100: Recommended Practice for the Repair of Rotating Electrical Apparatus and The Good Practice Guide of The Effect of Repair/Rewinding on Motor Efficiency.
Certifications:
Location:
701 Bill Myles Dr West, Saraland, AL 36571
Contact:
24/7 Phone: 800-932-2065
FAX: 251-675-3369
Facility Capabilities
- AC/DC motor and generator rewind, refurbishment, repair
- Preventive and predictive maintenance
- Field service
- Hydro rewinds
- On-site rewind of large motors and generators
- Turbine inspection and rebuild
- Pump repair and refurbishment
- CO2 dry ice cleaning
- Transformer and switchgear testing and repair
- Total Motor Management®
Facility Equipment
- 40-ton crane
- 8′ x 10′ VPI
- 6′ x 6′ dip tank
- Burn out oven 10’x12’x12′
- Bake oven 12’x12’x14′
- Complete machine shop – up to 65-in. swing by 15-ft travel lathe
- Horizontal milling with 12-ft cutting swing
- 150-ton horizontal press
- Rebabbit bearings (spin or puddle) up to 12-in.
- Electroplating (nickel-based up to 500 Amps)
- IRD 290 dynamic balance stand (10-ton/108-in diameter)
- Hard balancer=6,500 lbs
- 13,800 Volt test stand with vibration and bearing temperature analysis
- Water cooled load test dynamometer up to 1000HP @ 3600RPM
- Metal spraying
- PDMA testing
- Desalination tanks